EN
Refi lling
6. Pull the balloon down from the balloon tube a little. There should be around 1 cm of
space in the balloon before the balloon tube begins so that the water can fl ow into
the balloon unimpeded.
7. Make sure that the O-ring sits roughly 1 cm below the opening of the balloon so that
it can seal the balloon when it drops down and does not slide off.
Cleaning and Storage
•
Do not use any caustic or abrasive cleaning agents for cleaning. These can damage
the surface.
•
Clean the article under running water and a little mild detergent if necessary.
•
Store the article and all accessories in a clean, dry place that is not accessible to
children under 8 years of age or animals.
Disposal
The packaging material is recyclable. Please dispose of it in an environmentally
friendly manner and take it to a recycling centre. Dispose of the article in an en-
vironmentally friendly manner. You can obtain more information from your local
authorities.
Customer Service / Importer:
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany
Tel.: +49 38851 314650
09973_DE-EN-FR-NL_A5_V3.indb 12
09973_DE-EN-FR-NL_A5_V3.indb 12
12
1. Slide one or more O-rings onto the attachment aid.
2. Slide one balloon onto a balloon tube.
3. Place the balloon with the balloon tube into the notch
on the attachment aid.
4. Pull an O-ring over the balloon sitting in the notch.
5. Remove the attachment aid.
(Calls subject to a charge. Costs vary depending on the provider)
All rights reserved.
18.02.2016 07:36:31
18.02.2016 07:36:31