Assembly Instructions - wasserballon-fabrik Z 09973 Gebrauchsanleitung

Assembly Instructions

Tip: For more informationen please visit: www.wasserballon-fabrik.de.
CAUTION!
■
The article is only suitable for use on clear spaces outdoors (lawns etc.). Keep a suf-
fi ciently safe distance away from roads, sources of fi re and heat or similar potential
hazards.
■
Water may escape when the balloons are being fi lled. Keep a suffi cient distance away
from power sources and from surfaces and objects that are sensitive to water.
■
Do not expose the article to any extreme weather conditions (storms, hail, snow etc.).
When the article is supplied, the fi rst 88 balloons are already attached to the
balloon tubes.
09973_DE-EN-FR-NL_A5_V3.indb 11 09973_DE-EN-FR-NL_A5_V3.indb 11
11
1. Depending on how many water balloons you want
A
to fi ll at the same time, use one attachment or screw
two, three or four attachments (B) together.
B
2. Screw the seal cap (C) onto the bottom attachment.
3. Screw the attachments either onto the outside wa-
ter tap or screw the water tap adapter that is also
supplied onto the top attachment and plug the article
onto a commercially available garden hose with a
plug-on adapter (e.g. Gardena or similar).
C
4. Place a container, e.g. a bucket, below the article
and hold the article above it.
Tip: To get the best possible result, allow a little wa-
ter into the container before you fi ll the balloons so
that the balloons can rest in the water while they are
being fi lled.
5. Turn on the water tap. The balloons will start to fi ll.
6. Once the balloons are full, they will fall off the bal-
loon tubes on their own and will then be sealed with
the O-rings at the same time.
7. Turn off the water.
EN
18.02.2016 07:36:29 18.02.2016 07:36:29