Daylight Boost/ Fast 100; Dmx-Channel Selection; Dmx-Mode - Carpetlight CARPETINO Bedienungsanleitung

1. daylight Boost/ fast 100 %

Daylight Boost:
- Hold down the color temperature control knob for 3 seconds (menu-mode).
- Rotate the color temperature control knob 1 click to the right to activate the
"Daylight Boost".
- DLB will show up on the display.
- Turning any control knob will bring back the lamp operation mode.
Fast 100 %:
The lamp can, without using manual control, immediately be used at 100% brightness:
- Hold down the color temperature control knob for 3 seconds (menu-mode).
- Rotate the brightness control knob to the right for a 100% start.
- 100 will show up on the display.
The lamp will switch back automatically into the lamp operation mode.

2. dmX-Channel selection

Setting the DMX-Channel Selection:
- Press the color temperature control knob for 3 seconds (menu-mode).
- press the color temperature control knob briefly to go to the menu function
"DMX".
- Use the brightness control knob to select the required start address (1-511).
- By pressing the brightness control knob again for 3 seconds you enter the
wanted input and revert to the lamp operation mode.

3. dmX-mode

Turning off the DMX-mode with connected DMX-cable:
The control unit will automatically turn to the (DMX-Mode: Normal) once a DMX-signal
is received. By turning the DMX-mode to "OFF" you can carry out manual alterations to
the DMX-operation.
- Press the color temperature control knob for 3 seconds (menu-mode).
- press the color temperature control knob briefly to get to the menu function
"DMX-Mode".
- Use the brightness control knob to choose the required input. DMX is on
"Normal"- DMX is off "OFF".
- By pressing the color temperature control knob again for 3 seconds the input is
selected and the lamp reverts to the lamp operation mode.
- Upon restarting the control unit will revert to the "ON" position, as long as a
DMX-signal is present.
Please note, when in DMX "Stand Alone" use, or when the lamp is the last in the DMX
chain, the use of a 120 Ω (Ohm) termination/load resistor could be necessary (Not
included with the lamp).
menu functions
24