Zulassungshinweise; Modellspezifische Zulassungsnummer; Geräuschemissionen Des Produkts; Usa - Elektromagnetische Verträglichkeit (Emv) - HP DesignJet T1700 Series Hinweise

5

Zulassungshinweise

Modellspezifische Zulassungsnummer

Dem Gerät wurde zu Identifikationszwecken eine modellspezifische Zulassungsnummer zugewiesen. Die
Zulassungsnummer für dieses Gerät lautet BCLAA-1702. Diese Nummer darf nicht mit der Handelsbezeichnung
(z. B. HP DesignJet Drucker) oder der Produktnummer (z. B. Z####X, wobei Z und X ein beliebiger Buchstabe
sind und # eine beliebige Ziffer ist) verwechselt werden.
Geräuschemissionen des Produkts
Schalldruckpegel in der unmittelbaren Umgebung des Geräts (LpA gemäß ISO 7779) < 70 dB(A).
USA – Elektromagnetische Verträglichkeit (EMV)
The U.S. Federal Communications Commission (in 47 cfr15.105) has specified that the following notices be
brought to the attention of users of this product.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Shielded cables: Use of shielded data cables is required to comply with the Class B limits of Part 15 of the FCC
Rules.
ACHTUNG:
expressly approved by the HP Company may cause harmful interference and void the FCC authorization to
operate this equipment.
Note
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient the receiving antenna.
●
Increase the separation between the equipment and the receiver.
●
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
●
Consult your dealer or an experienced radio/TV technician.
●
For further information, contact:
12 Kapitel 5 Zulassungshinweise
Pursuant to Part 15.21 of the FCC Rules, any changes or modifications to this equipment not
DEWW