Veria Quickmat 150 Installationsanleitung Seite 2

Product specifications – Veria Quickmat 100/150 W/m²
Veria Quickmat is a 1-conductor heating mat which, due to the low fitting height
(approx. 2.5 mm), is particularly suitable for renovating existing floors.
Your underlay/under-floor will decide how big an output your Veria Quickmat should
have. Follow the instructions in the table below.
Note that the heating mat must be connected to the power supply by an authorised
electrician.
Areas of application
Wooden floor underlay with carpet, vinyl
or parquet on top
Wooden floor underlay with tiles on top
Concrete floors with carpet, vinyl or
parquet on top
Concrete floors with tiles on top
The product must be used to heat the floor directly.
The heating mat must be embedded.
Note that the yellow cable must not be cut under any circumstances.
The heating mat/cable must never be double-laid, overlap or cross over itself.
Connection:
Phase:
Neutral:
Earth:
2
Max.surface
Max. output per m²
temperature
100W/m
2
100W/m
2
100W/m
2
150W/m
2
Voltage:
W x L:
Max. temperature:
Certified by:
Thermostat with floor sensor and max.
27˚C
temp. 35 degrees
Thermostat with floor sensor and max.
27˚C
temp. 35 degrees
Thermostat with floor sensor and max.
27˚C
temp. 35 degrees
Thermostat with floor sensor and max.
None
temp. 45 degrees
230 V
See Label
120 ˚C
Semko
Thermostat