MOCK Mockmill 100 Bedienungsanleitung Seite 30

adjust the grinding mechanism
accordingly: With the mill
switched on, move the lever as
far as it will go towards 10. Now
turn the adjusting lever slightly
counter clockwise. The lever now
moves freely back and forth.
Move the lever all the way back
to postion 1 and tighten it back
up (by turning it clockwise).
When you now set it to 10, you
will get significantly coarser
meal.
You can repeat this procedure
again if the grinding result is
still not coarse enough for your
purposes.
12
To adjust the setting back
again to the fine range, proceed
as follows: Move the lever –
slowly – all the way to position
1. Now loosen it and move it over
to position 10. In this position,
tighten the adjusting lever
again. Repeat this procedure as
often as you did before for the
"coarse" setting.
In position 1 you will then hear
the quiet ticking noise made by
the grinding stones when there
is no more material to be ground
in the mill. Your mill is now set
for a fine grinding result again.
Once you have tried out the
procedure, it is easy to use.
Please visit our website at
mockmill.com/products/
operatinginstructions to find
out how to proceed.