Asus ET2411 Bedienungsanleitung Seite 5

Configuring a dynamic IP/PPPoE network connection
To configure a dynamic IP/PPPoE or static IP network connection:
1. From the Start screen, click Desktop to launch the Desktop mode.
2. From the Windows
and Sharing Center.
From the Open Network and Sharing Center screen, click Change Adapter settings.
3.
Right-click on your LAN and select Properties.
4.
Click Internet Protocol Version 4(TCP/IPv4) and click Properties.
5.
Click Obtain an IP address automatically and click OK.
6.
NOTE: Continue to the next steps if you are using PPPoE connection.
Return to the Network and Sharing Center and then click Set up a new connection
7.
or network.
Select Connect to the Internet and click Next.
8.
9. Select Broadband (PPPoE) and click Next.
10. Enter your User name, Password, and Connection name. Click Connect.
11. Click Close to finish the configuration.
12. Click the network icon in the taskbar and click the connection you just created.
13. Enter your user name and password. Click Connect to connect to the Internet.
Configuring a static IP network connection
To configure a static IP network connection:
Repeat steps 1 to 4 of the previous section Configuring a dynamic IP/PPPoE network
1.
connection.
Click Use the following IP address.
2
3. Enter the IP address, Subnet mask and Gateway from your service provider.
4. If needed, enter the preferred DNS Server address and alternative address.
When done, click OK.
5.
taskbar, right-click the network icon
®
and click Open Network