Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Volume
1
2
Power I/O
ANT.A / ANT.B
3
Audio Out
4
Battery compartment
5
MIC socket
6
Power I/O
7
LOW BATT LED
8
9
Headset
•
Connect the receiver to a mains outlet socket and insert batteries into the microphones.
•
Connect the anntenas on the rear of the receiver (ANT. A/ANT. B) and turn them into an upright position.
•
Connect the receiver to your PA / home stereo / other audio device.
•
Connect the headset microphones to the belt pack (MIC IN).
•
Switch the receiver on, then switch the microphone(s) on.
•
Use the GAIN knob to adjust the input sensitivity of the microphones. Adjust the output volume with the channel
volume knobs on the receiver.
•
The channel LEDs on the receiver indicate, if a proper signal from the microphone(s) is being received.
•
When the LOW BATT LED on the microphone lights up, please replace the batteries. Make sure to use the same
model and mind the correct polarity. To change the batteries, unscrew the bottom end of hand held microphones
(see below) / open the battery compartment of the belt pack. The assigned transmission frequency can be found
inside the battery compartment, too:
According to the European waste regulation 2002/96/EG this symbol on the product or on its pa-
ckaging indicates that this product may not be treated as household waste. Instead it should be
taken to the appropriate collection point for the recycling of electrical and electronic equipment. By
ensuring this product is disposed of correctly, you will hep prevent potential negative consequences
for the environment and human health, which could otherwise be caused by inappropriate waste
handling of this product. For more detailled information about recycling of this product, please con-
tact your local council or your household waste disposial service.
Producer: CHAL-TEC GmbH, Wallstraße 16, 10179 Berlin, Germany
This product is conform to the following European directives:
2004/108/EC
(EMC)
2011/65/EU
(RoHS)
Adjust output volume of receiver here
Antenna sockets
To connect with your hifi / P.A.
Connect your headset microphone here
(Beltpack on/off)
Indicates low battery
Environment Concerns
Declaration of Conformity
10
Werbung
Inhaltsverzeichnis
