Ten-Haaft Vision V5 Anleitung Seite 5

MoUNTING USING THE ADHESIVE STrIpS (ALrEADy IN pLACE)
remove any grease and dust from the adhesive surface before mounting the control device.
using the adhesive strip, the control device can be mounted to any even surface of 120 x 72 mm. Cut out the
drilling template and place it on this surface. the drilling point indicated marks the centre for the opening for
the Western connector. this connector requires an opening of at least 20 mm. the Western cable is then routed
through this opening and plugged into the control device. Once the Western cable is plugged in, remove the
backing film of the adhesive strips and secure the control device in position. The bonding strength is determined
by the maximum force applied when pressing the control device onto the strips, not the duration of pressing!
MoUNTING USING THE WALL ADApTEr
Copy the drill pattern for the 4 screws from the wall adapter and pre-drill
the mounting holes using a 2.2-mm drill bit. route the Western cable to
the control device. make an opening for the cable at the wall adapter as
required.
there are 10 positions where the material thinned-out so that the material
can be easily broken out to create a pass-through.
route the Western cable underneath the wall adapter and secure it with screws. Plug the Western cable into the
control device and then snap the device into the wall adapter.
TEMpLATE
froNT fACE of TEMpLATE
drilling point for
mounting using
adhesive strips