Connecting The Can Bus Interface - Waeco MagicSpeed CBI 150 Montage- Und Bedienungsanleitung

_IA_Can Interface.book Seite 11 Freitag, 26. November 2010 3:25 15
MagicSpeed CBI 150
6

Connecting the CAN bus interface

NOTE
I
The configuration of the OBD-II plug can be found in fig. 6.
Supplementary to fig. 5
➤ Before installation, make sure that the output signals you need for your
vehicle are available from CBI150.
You can find a detailed vehicle list at:
htp://www.dometic-waeco.de/cbi150.
NOTE
I
Only connect the cables to the CAN bus cables in the vehicle which
are specified in the vehicle list.
➤ Connect the white and the blue cables with the CAN bus cables as
described in the vehicle list.
➤ Insert the plug of the connection cable into the socket of the CAN bus
interface.
➤ Switch on the ignition.
✓ The status LED indicates the system status.
Status LED flashes: the vehicle type has been recognised
You can use the CAN bus interface.
You can test the functions as follows:
➤ Switch the ignition and all the consumer units off.
➤ Remove the ignition key.
➤ Close and lock all the vehicle doors.
✓ The status LED goes out after a delay time (depending on the model).
Connecting the CAN bus interface
11