NEFF B 1452 CO Gebrauchsanleitung Seite 68

After deactivating the oven
cleaning function
Rapid drying
68
Cleaning tips:
Never leave the residual water in the oven for any
length of time, e.g. overnight.
1.
Open the oven door and pick up the remaining
water with a large absorbent sponge cloth.
2.
Using the detergent-soaked sponge cloth, a soft
brush or a plastic pot scrubber, wipe of the oven
interior.
Stubborn soil remnants can be removed with a
cleaning scraper for glass-ceramic.
Caution: Use the scraper carefully, and do not
apply the tool at too flat an angle, because the
enamel could be scratched!
3.
Calciferous deposits may be removed with a cloth
soaked in vinegar.
4.
Wipe clean with clear water and dry with a soft
cloth (do not forget to wipe under the oven door
seal).
Cleaning tips:
If the oven is heavily soiled, the procedure may be
repeated after the oven has cooled.
If the oven is heavily soiled with grease, e.g. after
roasting or grilling, we would recommend rubbing
any stubborn dirt with detergent before activating the
oven cleaning function.
After cleaning, leave the oven door in its slanted
detent position, i.e., at a 30-degree angle, to allow
the interior enamel surfaces to dry thoroughly.
1.
Place the oven door into the slanted detent
position, at an angle of approximately
30 degrees.
2.
Turn the function selector to the
the temperature selector to the 50° C.
Allow oven to heat for 5 minutes.
3.
Afterwards return the function selector and the
temperature selector to the »0« position.
*
position, and