Troubleshooting - Remington NE3450 Bedienungsanleitung

ENGLISH
• To attach the comb onto the detail trimmer (NE3750), ensure the trimmer
blade is facing away from you and then slide the guide comb over the back
of the trimmer blade until fitted securely.
• Hold trimmer with cutting blade facing you.
• Use a small comb to lift the hairs. Hold the comb at the desired beard or
moustache length.
• Move the trimmer along the comb to cut the hairs. Use light pressure and
well-controlled movements to trim hair.
, CARE FOR YOUR GROOMER
• Care for your product to ensure a long lasting performance. We
recommend that you clean your groomer after each use.
, WASHOUT PORT INSTRUCTIONS.
• For best results, keep trimmer running while running it under the tap,
allow water to run through the washout port and over the blades.
Recommended to rinse after each use.

, Troubleshooting

•
The trimmer is not running but has battery power left:
• If the trimmer is not running it may need cleaning; rinse the trimmer in
warm water with the unit turned on. If the trimmer still won't run, look for
and remove any dried debris from the cutting blades.
, AFTER EACH USE
• Rinse the accumulated hair from the cutters as noted above and shake off
excess water.
C CLEANING CAUTIONS
• Do not use harsh or corrosive cleaners on the units or their blades.
• Do not apply pressure or hard objects to cutters.
• Do not submerge in water as damage will occur.
BATTERY REMOVAL
• Rotate the battery compartment cap approximately ¼ turn anti-clockwise
then pull off.
• Place the cap back on the unit opposite to how it came off and rotate
clockwise until the cap snaps into place.
•
The battery must be removed from the appliance before it is scrapped.
•
The battery is to be disposed of safely.
5