Replacing The Fuse; Technical Specifications - TechGrow Clima Control Plus Bedienungsanleitung

Replacing the fuse:

If a short circuit occurs by overload of one of the
outlets, the fuse will blow.
The fuse is placed on the left side of the controller,
left of the outlet.
Remove the fuse from the black casing by using a
screwdriver.
Now, the fuse can be replaced by a new one. A
spare fuse is supplied.
Put the new fuse in the black casing and place
them back in the holder.
Rotate the screwdriver a quarter turn to the right to
close.
If the fuse of one of the outlets has blown, the
controller itself and the possible connected devices
(Sensor, Datalogger, AM-T) will remain operating.

TECHNICAL SPECIFICATIONS:

Power supply:
Consumption:
Maximum fan capacity:
Maximum heater capacity:
Maximum total capacity:
Measurement interval:
Adjustment range TMP:
Adjustment range TMP hysteresis:0.0 to 5.0 C.
Adjustment range TMP off set:
100 to 240 Volt
3 Watt (with sensor, without fan)
7 Amp / 1700W
14 Amp / 3400W
14A
16A
1 second
10.0 to 45.0 C.
-5.0 to + 5.0 C.