Troubleshooting; Specifications - Yaesu ZCUT - 9 Gebrauchsanleitung

INSTRUCTION MANUAL: ZCUT - 9, ZCUT - 9 GR, ZCUT - 10
TROUBLE SHOOTING
Before returning the machine for repairing, please check the followings.
PROBLEM
The POWER SWITCH is on but
the machine can not run.
After removing piece of tape, the next piece
does not feed under AUTO mode.
The BLADE can not move smoothly.
The length of the tape is different from the
set length.
Tape curls excessively.
IF THE MACHINE STILL CAN NOT OPERATE PROPERLY, STOP USING THE MACHINE C )
!
IMMEDIATELY AND CONTACT VENDOR FOR REPAIR AUTHORIZATION.

SPECIFICATIONS

Power Requirement
Input Voltage Range
Wattage
Dimensions
Weight
Body Material
Tape Length
Tape Width
Feeding Speed
Max. Outside Dia. of Roll
Accessories
Remarks
• The specifications are subject to change without prior notice.
• The length of the tape may differ from the set length depending upon the type of the tape or its condition.
• Some types of tape available with the machine may not be cut depending upon conditions.
30
POSSIBLE REASON
The AC CORD is loosen.
The FUSE has been blown.
The mode is set MANUAL.
Some debris are covering on the SENSORS.
The tape can not goes through the SENSORS.
The tape has extremely low reflectance.
The BLADE UNIT is not in a proper position.
The adhesive of tape is too strong.
The elasticity of tape is too strong.
The machine is not grounded.
The ROLLER LOCK is disengaged.
100-240VAC 50/60Hz
±5%
25W
116 mm(S) x 140 mm(W) x 213 mm(G)
1.6 kg.
ABS
5 mm ~ 999 mm
6 mm~60 mm
200 mm/s. (using Craft Tape)
300 mm
24 Fuse (built-in inlet)
Separator / Guide Plate / Blade Oil
SOLUTION
Check the AC CORD then plug in the outlet
firmly. Replace the FUSE.
Stop using the machine immediately even
though the FUSE is blown again after replace
Set the mode to AUTO.
Remove the debris.
Use SEPARATOR to narrow the tape lesser
than 25mm,
Do not bring strong illuminant close around
the SENSORS.
Some types of tape may not be used under
AUTO mode.
Check the BLADE UNIT and push down on
the housing firmly.
Correct the setting after cutting several
test pieces.
Check ground on cord.
Engage the ROLLER LOCK to apply tension.