Error Messages - Yaesu ZCUT - 9 Gebrauchsanleitung

INSTRUCTION MANUAL: ZCUT - 9, ZCUT - 9 GR, ZCUT - 10
Always keep clean around the SENSORS.
To protect the SENSOR, clean the openings after removed the BLADE UNIT carefully.
ROLLER UNIT
When waste of tape glue is found, please refer to page 14 and follow the procedure for cleaning
ROLLER UNIT.

ERROR MESSAGES

The buzzer will has a sound then a message will flash and show on the DISPLAY.
E-02 BLADE IS OUT OF POSITION
A signal shows that the blade is not installed well or machine stops because of the thickness or
hardness of the tape.
Turn the POWER SWITCH off.
Remove the BLADE UNIT by releasing the BLADE UNIT RELEASING LEVER then lift the assembly
out of the body.
Turn the POWER SWITCH on.
Press the FWD BUTTON and feed -in the tape once, cut the tape in between the TAPE OUTLET
and the BLADE UNIT by scissor.
Press the REV BUTTON to remove the tape.
Clean the BLADE UNIT and lubricate the LOWER BLADE GUIDE.
Check the lower blade position and replace the BLADE UNIT.
E-03 MOTOR IS STOPPED
Indicates that the motor is stopped because of overload.
Press the START BUTTON to clear the error message.
Press the REV BUTTON to remove the tape.
Turn the POWER SWITCH off.
Check the BLADE UNIT and TAPE OUTLET carefully.
Clear and take away the spare tape waste or sticky residue by using tweezers.
(Clean ROLLER UNIT as depends on the condition.)
!
DO NOT TOUCH THE BLADE WHEN YOU ARE CORRECTING AN ERROR UNDER POWER SWITCH
TURN OFF THE POWER SWITCH AND STOP USING THE MACHINE.
!
IF THE MACHINE CANNOT WORK NORMALLY AFTER CORRECTING THE ERROR.
IT SEEMS THAT NOTHING WRONG WITHOUT ANY ERROR MESSAGES.
DO NOT USE THE TAPE IF STATIC ELECTRICITY GENERATES OVER 1000V.
!
IT MAY CAUSE FAILURE TO THE MACHINE.
28