Edy EDPA1001 Bedienungsanleitung Seite 28

DRAINAGE
During the process of cooling, some water will be extracted from the air into the unit. If the
reservoir is full, both of the compressor and motor will stop. The "water full" sign will light on, also
the machine will beep as reminder.
To make the cooling work again, please empty the water by one of the following ways:
1. Turn off the air conditioner and avoid
moving it when full.
2. Position a container (a water tray for
example) underneath the drain hole.
3. Remove the drain knob & rubber plug
from the drain hole and allow the water to
drain out.
4. When the container is almost full, replace
the rubber plug in the drain hole and
empty the water tray.
5. Repeat until the unit is emptied.
6. Replace the rubber plug and tighten the
drain knob firmly.
7. Switch on the unit - the full water or
compressor operating indicator should
not be flashing.
If you wish to operate the unit without the need to empty the water tank, please:

Remove the drain knob and rubber
plug and retain for future use.
Drain hole
Rubber plug
11
Drain Knob
FIG.22
FIG.23