Edy EDPA1001 Bedienungsanleitung Seite 27

EFFICIENCY BOOSTING
This unit is equipped with "energy efficiency
boosting" function, by adding 1.2L water to the
water funnel at the side of the unit, the energy
efficiency can be elevated. The principle is:
while the machine is working, the condenser
will be getting hot, if you add the water into the
unit after the unit has been worked for more
than one hour, the water will cool down the
condenser, so it will consume less power, i.e.
saving power.
NOTE !
1.
This efficiency feature by adding
water is proposed to do after one
hour operation and the water should
NOT be over 1.2L, otherwise, the
"water full" indicator will light in red
and the unit will stop working.
In case the "water full" indicator is
2.
in red, please drain the water from
the drain point at the back side of
the unit until the red light goes out.
The unit should work again now.
IMPORTANT !
1. To prolong the compressor's life, after switch-off of the unit, please wait for 3 minutes (at
least) before re-switch.
2. The cooling system will switch off if the ambient temperature is lower than the set one. The
ventilation, however, keeps working at the set level. If the ambient temperature rises above
the selected level, the cooling will return to work.
FIG.21
1. Pull out the
water funnel
2. Add 1.2 L
water to the
funnel
3. Push back
the water
funnel
10