List Of Items Supplied; Steps In The Installation Process - AQUALUX 104274 Installation

Non-contractual scheme, pool water input / output water on back side
Dim (mm) A
310
104274
390
104275
390
104276
500
104277
500
104278
500
104279

LIST OF ITEMS SUPPLIED

1 heat pump + 2 x 50mm diameter fittings + condensate drain
-
1 digital remote control panel + 10 m of cable
-
1 manual
-

STEPS IN THE INSTALLATION PROCESS

Position
- The heat pump must be installed OUSTSIDE in a well ventilated place, far from any sources of
combustibles. In order to reduce noise levels, position the fan (air inlet – outlet) parallel to the living
space.
The water pipe between the pool and the heat pump must not exceed 10m.
Provide for the discharge by gravity of condensates under the machine.
For maintenance reasons, the pump must not be placed in an area where vegetation is present (leaves,
pine needles, etc.).
Ideally, the heat pump should be protected against outdoor phenomena (rain, snow, etc.) by a shelter.
- The frame is secured with screws (M10) on a concrete slab type structure solid and sets capable of
supporting the weight of the heat pump and allowing the natural evacuation of rainwater and condensate.
Wood supports or other deformable, corrodible and / or hydrophobic material is prohibited. The
mounting of anti-noise systems is recommended ref 104284 (optional).
NOTPACAQX - ind Q – 0413
B C
590 300
590 380
590 380
790 490
790 490
790 490
Heatpump
pummpe
Technical room
Pool
D E
340 961
420 961
420 961
530 1161
530 1161
530 1161
50 cm mini
control panel
14/41
F G
280 107
290 107
290 107
600 107
600 107
600 107
H
658
658
658
958
958
958