Malfunctions - Kessebohmer TouchControl Bedienungsanleitung

Malfunctions

Malfunction Possible causes
No function of the The power supply of the
drive and the TouchControl is interrupted.
green signal lamp
does not light up.
Power failure
No function of the The front adapter has not
drive and the green been positioned correctly.
signal lamp lights
up.
Drive is blocked.
Drive works, The front sensor has been
but does not react switched off.
to knocks on the
The front sensor does
front.
not have contact with the front.
The gap between the drive and
the sensor is too large.
The front sensor is defective.
The drive opens The front adapter has not been
by itself. fixed.
Non-interference suppressed
devices in the direct surroundings.
The installation of the components
should be carried out according to
the installation instruction.
18 l KESSEBÖHMER
Remedy
If necessary, plug in the socket or
re- esta blish the power supply on the
device.
- Check the fuses in your
domestic electricity supply.
- Consult an authorised
electrician if required.
- Check if the draw bar has been
fitted and if necessary,
fix retaining screw.
- See the installation instructions.
- Remove any objects that may
block the drive.
- If this does not solve the problem,
disconnect the system from the
electricity supply and report the fault
to Customer Service.
Switch the front sensor on.
- Check, that the front sensor
rests against the front, if necessary
fix the front adapter using the
securing screw.
- See the operating instructions.
Report the malfunction to the
customer services.
Report the malfunction to the
customer services.
Fix the front adapter using the
securing screw.
Remove these devices.
Report the malfunction to the
customer services.