Technical Data; Safety Instructions - auna AMP-5100 Anschluss- Und Anwendungshinweise

Dear Customer,
Congratulations on purchasing this equipment. Please read this manual carefully and take care of the following
hints to avoid damages. Any failure caused by ignoring the mentioned items and cautions mentioned in the inst-
ruction manual are not covered by our warranty and any liability.
Item number
Power supply
Input impedance
Input Sensitivity
Gain difference
Alt
Bass
SNR
Harmonic distorsion
Frequency response
Peak output power
• This machine can only be used with 230V, 50Hz AC power supply. Please inquire the local distributor or power
authority if you don't know the varieties of power supply.
• Please place the machine under ventilated environment. Please do not place the machine under direct sunshine
or heating source, do not place the machine in closed frame.When installing the frame, assure adequate venti-
lation holes for heat loss.
• Protect the power cord. Do not press the power cord with heavy objects or step on the power cord, do not pull
and twist the power cord fiercely. Please hold the plug when pulling it from the socket.
• Prevent forei gn objects falling into the machine Prevent pin, hair pin and coil falling into the machine for avoi-
ding damages.
• Protect the machine from dampness, water and dust. Do not place the machine in environments with high
dampness or too much dust. Do not place vase or other containers with water onto the machine. Do not expose
the machine under rain or water.
• Do not clean the machine with volatile soIvent. Do not use insecticide near the machine, do not wipe the case
• with such chemicals as alcohol, coating, diluent, gasoline and thinner. Wipe off dust with soft fabric.
• Do not jam the ventilation hole of the machine. It may possibly damage the machine if the ventilation hole is
• jammed. The ventilation holes are important for heat loss of the machine, it may cause the temperature in the
machine rises to extremely high level if the ventilation hole is jammed.
• Do not remove the cover without permit. it may possibly cause serious electric shock if the machine is repaired,
disassembled or assembled by non professional technicians or the internal parts are touched by mistake. There
isn't part which can be repaired by users. Please ask the qualified technicians to check and repair the machine
if necessary.

Technical Data

10003730
230 V ~ 50 Hz
47 KΩ
280 mV
≤ 2 dB
± 10 dB
± 10 dB
≥ 76 dB
< 0.5 %
± 2 dB
28 W

Safety Instructions

5