Dmx-Controlled Operation - EuroLite IR remote for LED effects Bedienungsanleitung

DMX-controlled operation

You can control the spots individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.
The starting address can be defined via the remote control and is the first channel from which the device will
respond to the controller.
Example for setting the DMX starting address 7:
Step 1: Turn off the DMX-controller.
Step 2: Press button S on the remote control. The red LEDs light, indicating you can start setting the
address.
Step 3: Press button 0. The green LEDs light. The setting of the 100
Step 4: Press button 0. The blue LEDs light. The setting of the 10
Step 5: Press button 7. All LEDs light. The setting of the 1
Step 6: Press button D. The spot changes to DMX mode.
Modifications occur in steps. Please do not hold the + and – buttons, rather press repeatedly.
Please make sure that you do not have any overlapping channels in order to control each device correctly
and independently from any other fixture on the DMX data link. If two, three or more devices are addressed
similarly, they will work similarly.
After having addressed all devices, you may now start operating these via your lighting controller.
Note: In order to change from DMX-controlled operation back to stand-alone operation, please disconnect
FUNCTION
Manual color adjustment
via the brightness of the RGB LEDs
Automatic change
speed for change of color adjustable
Sound-controlled color change*
*only available for indoor models
Programs
7 static colors; color change and color
fade with adjustable speed
Flash
speed of flash adjustable
Black Out
turns LEDs on and off
DMX starting address
DMX controlled mode
Slave mode
the device from the DMX-controller.
7/8
BUTTON
R
G
B
A
SP
SA
PROG
SP
F
S
D
SL
th
figure was successful.
th
figure was successful.
st
figure was successful.
00062838.DOC, Version 1.0
MODE
-
+
-
+
-
+
-
+
-
+
-
+
-
+
0 9