Installation - RCF MS 1033 Bedienungsanleitung

Use the UP (/ DOWN ) key in 3 possible ways:
22 21
-
If pressed for a while, the frequency increases (/ decreases) of 0.05 MHz (manual search).
-
If pressed for more than half a second and then released, the next (/ previous) station
is automatically searched.
- If pressed and held, the frequency continuously increases (/ decreases).
After finding your favourite station, this can be directly stored to 1 of the first 10 presets:
press MEMORY and (within 5 seconds) 1 of the 10 numeric keys (if possible, choose an
23
empty preset, not already assigned to another station), then press the MEMORY key again
to confirm.
Use the remote control to recall and store presets 11 to 60 (see the respective manual
section).
This device can be either installed into a 19" rack cabinet (1 unit) thanks to its rack ears or
put on a desk (after taking its rack ears off by removing the 4 screws on each side).
- Use 2 new AAA (1.5 V) non-rechargeable batteries, better if alkaline.
- Do NOT use old and new batteries at the same time.
- Do NOT put together different models of batteries.
- Do NOT attempt to charge non rechargeable batteries.
-
Verify the polarity of batteries is correct (inserted properly, following the indication on
the relevant compartment).
-
Remove batteries when empty or in the case the device will not be used for a long time.
- Do NOT short-circuit batteries (i.e. connecting the 2 opposite poles together with
metallic wires).
- Throw empty batteries into dedicated garbage cans, according to your country laws
about ecology and environment protection.
The battery compartment is on the bottom of the remote control rear side.
Push (slightly) the lever and pull the battery compartment cover to remove it (picture 1).
Remove old batteries (if present), by raising them from their positive pole.
The right polarity is indicated in the battery compartment (picture 2).
Insert 2 new AAA type (1.5 V) non-rechargeable batteries, better if alkaline. Assure the
polarity is correct when inserting. Battery insertion: first push its negative pole against the
compartment spring, then push down its positive pole (to fix the battery; picture 3).
SEARCH AND STORE RADIO
STATIONS AS PRESETS (TUNER)

INSTALLATION

INSERT / REMOVE / CHANGE THE
REMOTE CONTROL BATTERIES
picture 1 picture 2 picture 3
13