Lap Function; Count Down Timer - Diesnerfunk T641-F Bedienungshandbuch

T641-f_om_German_French_Eng.fm Page 26 Friday, November 28, 2003 5:04 PM
Note: You can press MODE button once to exit at any procedure of
the above. In other mode, the Stop Watch/Lap Function icon will keep
flashing once the Stop Watch/Lap function was enabled before.

Lap Function

1. During the time counting(STOP WATCH icon is flashing),
press RESET/SET button once to freeze the displayed count-
ing for easy reading. The timing function is still running, but
the display is not being updated. This is the Lap Function.
2. To exit from Lap function, press RESET/SET button again to
return to normal time counting. The display will now show
count activity.
3. When Lap function is activated, pressing the START/STOP
button will stop the background counting and the STOP icon
will stop flashing. To read the stopped time, press and release
the RESET/SET button once to display the stopped reading.
4. To clear the reading (with STOP icon), press and release
RESET/SET button once.

Count Down Timer

1. Under idle mode, press MODE button three times to enter into
Down Counter Mode. The 1st row of the display shows the
"TMR" message.
2. The Down Counter icon is turned ON and the display will
show 99'00" on the 2nd row and 99 on the 3rd row for the ini-
tial down count settings.
3. Press and release START/STOP button once to start down-
counting. The Down Counter icon is flashing .
4. Press and release START/STOP button again to pause or
stop the down-counting. The STOP icon will stop flashing and
is steadily ON.
5. Press and release START/STOP button again to resume the
down-counting process.
6. When the counting is stopped, press RESET/SET to clear the
counting and return to stand-by (step 2).
7. If count down timer reaches 00:00, it stops automatically and
alerts with a 2 minute alarm tone.
NOTE:
• The default (and maximum) down count period is 99 minutes.
-26-