Temperature; Clock With Alarm; Stop Watch With Lap Function - Diesnerfunk T641-F Bedienungshandbuch

T641-f_om_German_French_Eng.fm Page 25 Friday, November 28, 2003 5:04 PM
2. When the corresponding Wind Chill factor* falls below -13
(when temperature in ° F) or -25 (when temperature in °C), the
*COLD* icon will be displayed with a short reminder beep that
is generated every second.
Note: * Wind Chill factor depends on both wind speed and tempera-
ture.

Temperature

1. The temperature reading is ON by default during idle mode.
The current temperature will be shown on the 1st row of the
display and will be continuously updated every 30 seconds.
2. There are two types of temperature display option: degree C
and degree F. To select either option, please refer to "Set
Temperature Display Option" on page 23.

Clock with Alarm

1. The clock is ON by default during idle mode. The time is
shown in the 2nd and 3rd rows of the display. To set the time,
please refer to "Set Clock Time" on page 21.
2. The clock has an alarm function. Please refer to "Set Alarm
Time" on page 22 to set up alarm time.
3. When the clock alarms, the unit return to idle mode, without
any key press, the alarm tone will last for about 2 minutes.

Stop Watch with Lap function

1. Under idle mode, press and release the MODE button twice
to enter into Stop Watch mode. The 1st row of the LCD will
show the "STW" message.
2. The STOP WATCH icon is ON and the display shows 00'00"
on 2nd row and 00 on 3rd row.
3. Press START/STOP button once to start the up-counting of
the time. The STOP WATCH icon will flash.
4. Press START/STOP button again to stop or pause the count-
ing time. The STOP WATCH icon will stop flashing. Press
START/STOP again to restart counting.
5. When the count time is stopped, press and release RESET/
SET button to clear the time and return to stand-by (for
another timing activity).
-25-