Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
!"#*%')#(@#'(&*%
%
Step 2
Hold the drilling template on the wall/ceiling and orientate it by
using a water level.
Step 3
Mark the 4 drill positions (Please note that only the upper holes of the drilling template are relevant for wall mounting).
Tip: Before drilling the holes please check if tubes or wires are present in this area. Use a suitable metal detector.
Step 4
Drill the 4 holes by using a Ø6mm drill (depth=length of the dowel').
The depth of the holes should not differ much from the dowel length (50mm).
To ensure this demand please mark the drill or use a depth stop.
Tip: To avoid the formation of dust it is recommended to use a vacuum cleaner
simultanously.
Step 5
Push the dowels in the holes and screw the screws in.
Step6
Hang the heater to the 4 screws. The heating panel has to be moved on the wall in a way that the
screw will be positioned on the upper point of the groove (red marked circle in the picture below).
The panel heater is fixed on the wall now.
Important: Although the infrared panel heater is equipped with a good thermal insulation there will
be higher tempertures also on the backside of the panel. If the heater is too close to the wall or
ceiling there could be a heat accumulation on the back. The mounting distance of 23mm must not
be underrun. An continual airflow behind the heater should be guaranteed.
GB
%
+,-.,/%012+03452613789#%"#$%:%;8//<=8>?%
&*%
Werbung
Inhaltsverzeichnis
