Preparing The Appliance For Operation - OK. OFK 46412 A2 Bedienungsanleitung

PREPARING THE APPLIANCE FOR OPERATION

It is recommended to prepare the appliance for operation with a helper.
• Remove package.
Never lift or push the refrigerator and freezer holding their handles as they
may break.
• Lift the appliance away from foamed polystyrene base.
• Tear off adhesive tapes.
• When positioning the appliance in chosen location, it will
move more easily into position if you lift the front a little
and incline it backward, allowing it to roll on its casters.
• Remove all red-coloured parts from the shelves (fig. 2). Tear away the red-coloured
adhesive tapes from the door trays – they are intended only for the transport of the
appliance.
NOTE. When you open the freezer compartment door a little red packing detail
will fall out – IT IS FOR TRANSPORTATION PURPOSES ONLY.
• Suitably dispose the packaging material.
• The appliance should not be connected to the mains until all packing and transport
materials aren't removed.
• Place the appliance in a dry, well ventilated room.
WARNING! The appliance should not be operated in an unheated room or porch.
Place the appliance away from heat sources such as kitchen stove/oven,
radiators, or direct sunlight.
WARNING! The appliance must not touch any pipes for heating, gas or water
supply, or any other electrical devices.
• Do not cover the ventilation holes at the top of the appliances – it
must be a good air circulation around the appliance.
should be a gap of at least 10 cm between the top of the
appliance body and any furniture that may be above it (see fig.).
If this requirement is not followed, the appliance consumes more
electrical energy and its compressor may overheat.
• The appliance must stand on a level surface and must not touch
the wall. If necessary, regulate the height of the appliance by
adjusting the levelling feet: by turning them clockwise – the front
of the appliance rises, by turning them counter clockwise – it
comes down. If the appliance is tilted slightly backward – the
doors will close by themselves.
OFK46412A2
DE
⊳ Take two supports 1 from the bag and insert them into
the guides 2 at the top back part of the appliance.
• If the appliance is brought in from the cold (temperature
is not higher than +12 ° C), you should wait for two hours
before connecting it to the mains.
POSITIONING
Version OK1.0_10/2014
There
Seite 27 von 36