Replacement Of Carbon Filter (Only For Circulating Air Mode) - Otto SY-3388C1-IS Gebrauchsanleitung

Care and maintenance
3. Wash the grease filters in the dishwasher or sink like normal crockery.
4. Once the grease filters are completely dried, insert the grease filters into the
recess at the rear.
5. Push the lock backwards, press the front of grease filters into place and
release the lock. The grease filters click into place.
6. Restore the power supply.
The carbon filter is to remove the odours. It must be replaced when the odours

Replacement of carbon filter (only for circulating air mode)

generated by cooking can no longer be sufficiently filtered. If used regularly, the
filter should be replaced approximately every three months.
1. Disconnect the mains plug or isolate at the appropriate main fuse.
2. Push the lock on the two grease filters 1a backwards and remove the grease
filters carefully downwards.
3. Turn the locks of the old carbon filter 1b to the side and remove the filter. It
can be disposed of in the domestic waste.
4. Insert the new carbon filter as shown and turn the locks back in front of the
filter.
5. Insert the grease filters 1a into the recess at the rear.
6. Push the lock backwards, press the front of grease filters into place and
release the lock. The grease filters click into place.
7. Reestablish the power supply.
1a
1b
General
17
English