Hitachi RAR-5G1 Anleitung Seite 3

NAMES AND FUNCTIONS OF REMOTE CONTROLLER
■ This controls the operation function and timer setting of the room air conditioner.
OPERATION LAMP
START/STOP Button
Press this button to start operation.
Press it again to stop operation.
MODE SELECTOR Button
Use this button to select the
operating mode. Every time you
press it, the mode will change
from (AUTO) to (HEAT)
to (DEHUMIDIFY) and to
(COOL) cyclically.
SLEEP Button
Use this button to set the sleep
timer. ( Page 10)
SET Button
Timer setting reservation.
OFF TIMER Button
Select the turn OFF timer.
ON TIMER Button
Select the turn ON timer.
Precautions for Use
Do not put the remote controller in the following places.
●
Under direct sunlight.
●
In the vicinity of a heater.
●
Handle the remote controller carefully. Do not drop it on the fl oor, and protect it from water.
●
Once the outdoor unit stops, it will not restart for about 3 minutes (unless you turn the power switch
●
off and on or unplug the power cord and plug it in again).
This is to protect the device and does not indicate a failure.
If you press the MODE SELECTOR button during operation, the device may stop for about 3 minutes
●
for protection.
– 3 –
Transmission Sign
The transmission sign blinks
when a signal has been
send.
RESET SWITCH
ROOM TEMPERATURE
Setting Button
Room temperature setting.
Value will change quicker
when keep pressing.
FAN SPEED Button
This determines the fan
speed. Every time you press
this button, the intensity of
circulation will change from
(AUTO) to (HIGH)
to (MED) to (LOW)
to (SILENT)(This button
allows selecting the optimal
or preferred fan speed for
each operation mode).
CANCEL Button
Cancel timer reservation.