HomeMatic HM-RC-Sec3HM-RC-Sec3-B Bedienungsanleitung Seite 18

(teach button)
To actuate teach mode on the remote control, press
the teach button with a pointed object. The remote
control is then in configuration mode, indicated with
a flashing green of the device LED. (If you want to
exit configuration mode, press the teach button
again.)
Press the operating button that you want to teach to
enter teach mode. The device LED flashes orange.
(Cancel by pressing the teach button briefly, the
device LED then turns red.)
If no teaching occurs, teach mode is automatically
ended after 20 seconds. If other devices are in teach
mode, these are taught.
Successful teaching is indicated with flashing green
(the length depends on whether the configuration is
still running).
34
Note: If the remote control is already taught
for a center and therefore is blocked for
direct training, it can still be put in teach mode as
described above, the device LED is illuminated in
red for 2 seconds after pressing an operating button
however. Direct teaching is not possible!
Min. 2 sec. green LED
2 sec red LED
Orange flashing
Brief orange flashing
and 2 sec red or green
(depending upon
success)
Remote control in
configuration mode
and illuminated red
with button actuation
Teaching successful
Teaching failed
Only remote control in
teach mode
Other device in teach
mode and remote
control put in teach
mode.
Remote control already
taught for center and is
therefore blocked from
direct teaching
35