Martin Yale P7200 Betriebsanleitung Seite 35

Fold Table Pin
Front Slots on Fold Tables go
around pins
Fold Tables
The Front and Back Fold Tables should come already inserted in the machine. If you need to remove
them for jam removal, insert them back into the machine as shown in Figures #7 and #8.
• Slots on the ends of both Fold Tables fit onto the 2 silver colored pins inside the machine (figure #6).
• The Fold Tables should rest on top of the silver tie rods (see figure #6).
• The Tables should go into the machine open end first
Hint: Many users find it easier to install the fold tables while looking at them from the
bottom (as seen in figure #6).
Figure 7
FRONT FOLD TABLE
ADJUSTING THE FOLD TABLES
Note: The RapidFold
sheet of paper to a letter fold appropriate for a standard business envelope. 230 Volt
machines (UK and Europe) are factory preset to fold a A4 sheet of paper to a letter fold.
Before attempting to set the P7200 to a fold different
than the factory setting, one must understand the dif-
ferent types of folds (see figure 9 for examples of
several common folds and their corresponding
icons). A half fold requires that only the first fold
table be set and used. All other folds require that
both fold tables be set up and used.
Double Fold Operation
All folding operations apart from the half fold require two folds be placed in the stock. This is the case in the
typical letter fold or Z-fold. The second fold table must be in the double fold position (position it is in as
received) to accomplish this. Use the following steps to create the different types of folds:
Bottom view of Installed Fold Table
(110 Volt version) comes factory preset to fold a 8 1/2" X 11"
TM
Figure 6
(exception: When doing a half fold, the
Back Fold Table should go in closed
end first. See Half Fold section on the
next page.)
Figure 8
BACK FOLD TABLE
LETTER HALF
(orange) (blue)
Fold types possible on the P7200
Silver Tie Rod
Cutouts in Fold Tables Rest
on Top of Tie Rods
Z-FOLD DOUBLE PARALLEL
(green) (yellow)
Figure 9