Speaker Adjustment; The Front Control Panel; Standby Switch And Leds - Adam S3X-H Bedienungsanleitung

4. Speaker Adjustment

4.1

The front control panel

On the front you will find a new, highly sophisticated control panel that allows
detailed fine-tuning of your loudspeakers to your particular room acoustics and
personal listening preferences. The following tips are intended to assist you at
using the controls in the best manner.
Please note that using the controls may have a great impact on the overall sound
characteristics of your loudspeakers. We recommend using the controls with
utmost care and only after several audio tests with familiar recordings.
4.2

Standby Switch and LEDs

The main power switch can be found on the rear of the
loudspeaker. On the front, there is switch for power on/
standby. In standby mode, the switch glows orange, in power
on mode it glows green.
To the right of the standby switch you can find
two LEDs:
• In case of an overload, the OL LED will flash
red. The protective circuit will safe your speaker
from damage.
• All SX-monitors (except S1X and S6X) can be retrofitted with a 24 bit/192 kHz
D/A Converter. The D/A LED glows blue when a converter is inserted in the input
on the rear side of the speaker.
S3X-H Manual / english
9