Sony RM-VZ800T Bedienungsanleitung Seite 27

Example: To programme the
procedure above to the SYSTEM
CONTROL B button
1
Press and while holding
SET, press the SYSTEM
CONTROL B button.
The SET indicator light turns
on.
SET
If a System Control function
(System Control Macro) has
already been set on the button,
the SET indicator flashes twice.
The setting procedure is
automatically cancelled.
2
Set the System Control
function.
With this example, press
buttons in sequence as below:
TV
1
AMP
1
VCR
You can programme up to 16
consecutive steps on each of
the SYSTEM CONTROL
buttons (A – D), including the
first step to select a Component
Select button.
3
Press SET to complete the
programming.
The SYSTEM CONTROL
button light turns off.
VCR
1
TV
VIDEO 1
1
N
To programme a new series of
operations for those buttons
which already have a control
programme have already been
set
Erase the programme (page 28).
Notes
• If you interrupt the procedure at any
point for over 20 seconds, the setting
mode ends and the series of
commands will be programmed up to
that point. In this case, clear the
programme (page 28) and start again
from Step 1 to set the entire program
from the beginning. You cannot
continue programming once the
setting mode ends.
• If a SYSTEM CONTROL button has
already "learned" a remote control
signal (page 14), you can programme
a System Control function (System
Control Macro), but the function will
not work until you clear the Leaning
function. To clear the Learning
function, see "Changing or erasing
the function of a "learned" button"
on page 20.
• If you change the component code
number (page 8) or programme a
new signal by using the Learning
function (page 14) on a key or a
button that has been programmed
with a series of commands of using
the System Control function, the new
signal will be transmitted when you
press the corresponding SYSTEM
CONTROL button.
• While in setting mode, you cannot
clear any operation step you have
programmed. If you have
programmed an incorrect operation
by mistake, start again from Step 1.
• If you try to programme more than 16
steps, the System Control setting
mode ends, and the 16 steps you have
programmed are registered. If you
want to programme the steps again,
clear the programme (page 28) and
start again from Step 1.
Continued
GB
27