Sony RM-VZ800T Bedienungsanleitung Seite 24

Controlling the Volume of Visual
Components Connected to an
Audio System (continued)
2
While holding % pressed,
press w + or w –.
To set all volume controls to
AMP
Press w + while holding %
pressed.
All Component Select buttons
light up when you press these
buttons, and then turn off
when you release them.
Press and while holding w +,
press %.
TV VCR SAT
Volume control setting
complete.
TV VCR SAT
To set only the audio
components' volume controls
to AMP
Press w – while holding %
pressed.
Only AMP lights up when you
press these buttons, and then
turns off when you release them.
Press and while holding w –,
press %.
TV VCR SAT
Volume control setting complete.
TV VCR SAT
GB
24
DVD AMP
DVD AMP
DVD AMP
DVD AMP
Visual components are:
TV, video cassette recorder,
analogue cable box, satellite
tuner, DVD player
Audio components are:
CD player, MD player,
cassette deck, amplifier
To cancel setting, press SET.
Notes
• If you used the Learning function to
programme the w +/– or % buttons
to send a signal to a component, the
procedure above will not change the
function of the w +/– and %
buttons.
• If you set a Learning function for
sending an amplifier's volume
control signal on a Component Select
button other than TV, the priority of
sending the signal is also set as
follows from highest to lowest
priority: AMP buttontVCR
buttontSAT buttontDVD button.
For example, if you "teach" the AMP
button and the VCR button to send
the amplifier's volume signal, when
you adjust the volume, the signals on
AMP button are sent to the amplifier
first. If you "teach" the AMP button
to send signals of other than for an
amplifier, the signals are sent to the
amplifier from the VCR button.