ZANKER ZKVS 1530 Benutzerinformation Seite 19

Using the detergent
Caution! Use only detergents for dishwashers.
Do not use more than the correct quantity of de-
tergent. Refer to the instructions on the detergent
packaging.
1
3
4
Detergent tablets do not fully dissolve with short
programmes and detergent residues can stay on
the dishes.
We recommend that you use detergent tablets with
long programmes.
2
5
If the programme has a
prewash phase, put a
small quantity of deter-
gent on the inner part of
the appliance door.
Setting and starting a programme
Setting mode
The appliance must be in setting mode to accept some
operations.
The appliance is in setting mode when, after the activa-
tion, all the programme indicators are off and the end
indicator flashes.
If the control panel shows other conditions, press and
hold the programme button until the appliance is in set-
ting mode.
Starting a programme
1. Open the water tap.
2. Press the on/off button to activate the appliance.
Make sure that the appliance is in setting mode.
3. Press continuously the programme button until the
indicator of the programme you want to set comes
on.
4. Close the appliance door. The programme starts.
Opening the door while the appliance operates
If you open the door, the appliance stops. When you
close the door, the appliance continues from the point
of interruption.
Cancelling the programme
1. Open the appliance door.
2. Press and hold the programme button until the indi-
cator of the set programme goes off and the end
indicator flashes.
Make sure that there is detergent in the detergent
dispenser before you start a new programme.
At the end of the programme
When the programme is completed, an intermittent
acoustic signal operates and the end indicator comes
on.
1. Press the on/off button to deactivate the appliance.
2. Close the water tap.
19