Replace Light Bulb - JUNO JKU 6435, JKU 6035 Gebrauchsanweisung

What to do if ...
Malfunction
Interior lighting does not
work.
Heavy build up of frost,
possibly also on the
door seal.
Unusual noises.
The compressor does
not start immediately
after changing the tem-
perature setting.
Water on the floor or on
storage shelves.

Replace light bulb

Warning! Danger of electrical shock! Before replacing the light
1
bulb switch appliance off and remove the mains plug, or switch
off or turn out the circuit breaker or fuse.
Light bulb specifications: 220-240 V, max. 15 W, socket: E 14
0 To switch off the appliance, turn the temperature regulator to
position "0".
0 Unplug the mains plug.
42
Possible Cause
Light bulb is defective.
Door seal is not air tight
(possibly after changing
over the hinges).
Appliance is not level.
The appliance is tou-
ching the wall or other
objects.
A component, e.g. a
pipe, on the rear of the
appliance is touching
another part of the
appliance or the wall.
This is normal, no error
has occurred.
Water drain hole is blok-
ked.
Remedy
Please look in the
"Replace light bulb" sec-
tion.
Carefully warm the lea-
king sections of the door
seal with a hair dryer
(not hotter than approx.
50 °C). At the same time
shape the warmed door
seal by hand such that it
sits correctly.
Readjust the feet.
Move the appliance
slightly.
If necessary, carefully
bend the component
out of the way.
The compressor starts
after a period of time.
See the "Cleaning and
Care" section.