Herunterladen Inhalt Inhalt Diese Seite drucken

Suck In Water From Vessel; Operation - Kärcher HDS 801 B Betriebsanleitung

Vorschau ausblenden Andere Handbücher für HDS 801 B:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

Suck in water from vessel

When fitted with the appropriate acces-
sories, this high-pressure cleaner can
draw in surface water, e.g. from water
butts or ponds.
Suction height max. 1m.
Danger
Never suck in water from a drinking water
container.
Danger
Never suck in liquids which contain sol-
vents like lacquer thinner, petrol, oil or unfil-
tered water. The sealings within the device
are not solvent resistant. The spray mist of
solvents is highly inflammable, explosive
and poisonous.
 Connect suction hose (minimum diame-
ter 3/4") with filter (accessory) to the
water connection point.
 Set dosing value for detergent to "0".

Operation

Danger
Risk of explosion!
Do not spray flammable liquids.
Danger
Place the appliance on firm surface.
The high pressure cleaner must not be
used by children. (Risk of accident on
account of improper use of the appli-
ance).
The high pressure spray generates high
levels of noise when the appliance is in
use. Risk of hearing impairment. Al-
ways use proper ear-protection aids
while working with the appliance.
The water jet coming out of the high
pressure nozzle causes the gun to re-
coil. Further, an angular spray pipe can
cause additional torque. Hence hold
the spray pipe and gun firmly.
Never direct the water jet on to persons,
animals, the appliance itself or electrical
components.
Vehicle tyres/ tyre valves may be
cleaned only with a minimum spray dis-
20
tance of 30 cm. Otherwise, the high
pressure spray can cause damage to
the vehicle tyre/ tyre valve. The discol-
ouring of the tyre is the fhe first sign of
damage. Damaged vehicle tyres are a
source of danger.
Do not spray materials contains asbestos
or other health-hazardous substances.
The operator must wear proper safety
gear to be protected against the water
sprays.
Pay attention to ensure that all screws
of all connecting hoses are tightened
properly.
The lever of the hand spray gun must
not be locked during the operation.
 Set pressure/temperature and deter-
gent concentration according to the sur-
face to be cleaned.
 Close the hand spray gun.
 Turn the casing of the nozzle till the de-
sired symbol matches the marking.
High pressure flat spray (25°)
for large dirt areas
High pressure circular spray
(0°) for specially stubborn dirt
Flat low pressure spray
(CHEM) for operating using de-
tergents or cleaning at low
pressure.
Select round or flat spray using touch-less
switching:
 Close the hand spray gun.
 Turn the spray-pipe that is inclined
about 45° downward to the left or the
right.
Note: To prevent damage due to too much
pressure, always position high pressure ray
first from a greater distance towards object
to be cleaned.
– 6
EN
Cleaning
Triple nozzle

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis