Safety Instructions; General Notes On Safety; High Pressure Hose - Kärcher HDS 801 B Betriebsanleitung

Please do not let mineral oil contaminated
waste water reach soil, water or the sew-
age system. Perform engine cleaning and
bottom cleaning therefore only on speci-
fied places with an oil trap.

Safety instructions

Danger
Do not use high pressure cleaners
–
when there has been an oil spill; move
the appliance to another spot and avoid
any sort of spark formation.
Do not store, spill or use fuel in the vi-
–
cinity of open flames or appliances such
as ovens, boilers, water heaters, etc.
that have an ignition flame or can gen-
erate sparks.
Keep even mildly inflammable objects
–
and materials away from the silencer (at
least 2 m).
Do not start the engine without the si-
–
lencer; check, clean and replace, if re-
quired, the silencer at regular intervals.
Do not use the engine in forest, bushes
–
or grassy areas without fitting a spark
receiver at the exhaust.
Except for setting jobs, do not run the
–
engine when the air filter is removed or
there is no cover over the suction sup-
port.
Do not make any adjustments to the
–
regulator springs, regulator bars or oth-
er parts that can bring forth an increase
in the engine speed.
Risk of burns! Do not touch hot silenc-
–
ers, cylinders or radiator ribs.
Do not put hands or feet close to mov-
–
ing or rotating parts.
Risk of poisoning! The appliance should
–
not be operated in closed rooms.

General notes on safety

Please follow the national rules and
–
regulations for fuel spray jets of the re-
spective country.
Please follow the national rules and
–
regulations for accident prevention of
the respective country. Fuel spray jets
must be tested regularly and the results
of these tests must be documented in
writing.
The heating appliance of the machine is
–
an ignition plant. All national laws and
regulations about heating systems must
also be followed.

High pressure hose

Danger
Risk of injury!
Only use original high-pressure hoses.
–
The high-pressure hose and the injec-
–
tion system must be suitable for the
maximum operating pressure given in
the Technical Data.
Avoid contact with chemicals.
–
Check the high-pressure hose daily.
–
Do not use hoses with kinks.
Stop using the high-pressure hose if the
external wire layer is visible.
Do not use the high-pressure hose any-
–
more if the winding is damaged.
Lay the high-pressure hoses in such a
–
way that no vehicle can drive over it.
Do not use high-pressure hoses that
–
have been driven over, kinked, pressed
or bent even if there is no externally vis-
ible damage.
Store the high-pressure hoses in such a
–
way that they are not subject to any me-
chanical load.
– 3
EN 17