Fault Messages; Fault Messages Green Status Led; Fault Indication - REMEHA iBase Bedienungsanleitung

6 Fault messages

A fault message is given by the green status LED. This is indicated by the following
flash patterns:
1. The LED first flashes on for 1 second ( ) and then off for 0.5 seconds ( ).
2. The LED then flashes a number of times as indicated in the table below to signify
the fault.
3. Thereafter, the LED is off for at least 0.5 seconds.
This flash pattern is repeated each time.

6.1 Fault messages green status LED

Fault indication

Problem
Solution
Green status LED flashes as follows:
No connection with iSense RF.
- Check whether the iSense RF indicates a fault or is on.
Try to re-establish the connection between the iSense RF and
-
the Base station; see Chapter 5.
- If this does not solve the problem, relocate the iSense RF or the
Base station or remove obstacles that can interfere with the RF
signal; see paragraph 3.1.
T001500-B
T001500-B
EN
30
T001500-B