AEG DD9693-M Montage- Und Gebrauchsanweisung Seite 18

Mounting the hood body
• Before attaching the hood body, tighten the two screws Vr lo-
cated on the hood body mounting points.
• Hook the hood body onto the screws 12a.
• Fully tighten support screws 12a.
• Adjust screws Vr to level the hood body.
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the
chimney using either a flexible or rigid pipe ø 150 or 120mm, the
choice of which is left to the installer.
To install a ø 150
• To install the dumper 10
• Fix the pipe in position using sufficient pipe clamps (not
supplied).
To install a ø 120
• To install a ø 120 mm air exhaust connection, insert the redu-
cer flange 9 on the dumper 10.
• Fix the pipe in position using sufficient pipe clamps (not
supplied).
• Remove any activated charcoal filters.
EN
Connections
Vr
12a
ø 150
9
10
10
ø 120
1
18
8