Connections; Connection With The Sound Source - Omnitronic WHP-500 Bedienungsanleitung

4.3 Headphones
(8) Harness
(9) Earpiece
(10) Battery compartment
(11) Power-LED

5. CONNECTIONS

5.1 Connection with the sound source

Connect the wireless sender via the Audio In-socket and a standard microphone lead with a line level output
socket of your mixer, sound-card etc.
Adjust the antenna vertically.
5.2 Connection with the mains
Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.
5.3 Inserting/Replacing the batteries
Please refer to the explanations under Operating Determinations.
Open the battery cover at the earpiece and remove it.
If replacing the batteries, remove the old batteries from the battery compartment.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty batteries in accordance with the instructions of the manufacturer.
Insert the batteries and make sure that the poles are correct.
Replace the battery cover and close it.
In order to have a long battery life, you should only use alcaline batteries.
Danger of explosion when batteries are replaced improperly.
(12) Power switch
(13) Volume-control
(14) Finetuning
Caution!
12/23 14013020_V_1_0.DOC