Setting And Starting Aprogramme; Setting Mode - AEG FAVORIT 45020 VI Benutzerinformation

34
USING THE DETERGENT
A
SETTING AND STARTING A
PROGRAMME

Setting mode

The appliance must be in setting mode
to accept some operations.
The appliance is in setting mode when,
after the activation:
• All the programme indicators come
on.
If the control panel shows other condi-
tions, press and hold function buttons
(B) and (C) at the same time until the
appliance is in setting mode.
Starting a programme without
delay start
1. Open the water tap.
B
30 A
20
+ -
C
CAUTION!
Use only detergents for dish-
washers.
1. Press the release button (B) to
open the lid (C).
2. Put the detergent in the compart-
ment (A) .
3. If the programme has a prewash
phase, put a small quantity of de-
tergent on the inner part of the ap-
pliance door.
4. If you use detergent tablets, put
the tablet in the compartment (A).
5. Close the lid. Make sure that the
release button locks into position.
Do not use more than the cor-
rect quantity of detergent. Refer
to the instructions on the deter-
gent packaging.
Detergent tablets do not fully
dissolve with short programmes
and detergent residues can stay
on the dishes.
We recommend that you use
detergent tablets with long pro-
grammes.
2. Press the on/off button to activate
the appliance. Make sure that the
appliance is in setting mode.
3. Press the button of the programme
you want to set.
• The related programme indicator
stays on.
• All the other programme indica-
tors go off.
4. Close the appliance door. The pro-
gramme starts.
Starting a programme with
delay start
1. Set the programme.
2. Press the delay button again and
again until the indicator of the num-
ber of hours you want to set comes
on. You can set 3, 6 or 9 hours.