Citrus Press - AEG Electrolux FP 4200 Gebrauchsanweisung

822_949_452 FP4200-4400_AEG.book Seite 18 Donnerstag, 12. Februar 2009 11:19 23
g
Inserting cutting insert in insert
holder (fig. 10)
The appropriate insert must be placed
in the insert holder depending on use.
3 The inserts are contained in the hinged
accessories compartment (fig. 1/K) in
the motor casing.
1 The inserts are very sharp. They should
be held only with the handle!
0 Open accessories compartment by
pulling the handle (fig. 9).
0 Take required insert by the handle from
the accessories compartment (fig. 9).
0 Place the insert with the tip at the cen-
tre of the insert holder and place in the
recess of the disk (fig. 10).
0 To remove the insert draw slightly out-
wards with the handle and raise.
Operating multifunction section
0 Open cover (fig. 1/F) and place all
ingredients required in the all-purpose
bowl.
Caution: Do not exceed maximum fill-
ing volume:
– liquid 1.75 litres
– solid 1.5 litres
3 Further ingredients can be added dur-
ing operation through the filling inlet.
The filling beaker in the stopper (fig.
1/E) can also be used for this purpose.
Close the filling inlet immediately each
time to avoid splashes.
Use the stopper exclusively to com-
1
press the cutting items!
0 Start the appliance: turn speed selector
(fig. 1/l) right to the desired speed set-
ting or press the pulse button (fig. 1/J).
3 It is recommended to start at a slow
speed and then to increase the speed.
The appliance operates at maximum
speed by pressing the pulse button.
Refer to the section "Tips on using
multifunction section" for reference
values.
18
1 If the warning lamp (fig. 4/a) flashes
and the appliance cannot be started,
the safety cover for the mixer drive
(figs. 1/T and 4) is not properly fitted.
0 Switch off appliance: turn speed selec-
tor left to the "0" position.
0 After using, turn cover clockwise and
remove.
1 Only remove the cover when the tool
has come to a complete stop!
0 Remove the tool and spindle.
0 Turn the all-purpose bowl clockwise
and remove.

Citrus press

Preparation (fig. 13)
0 Fit all-purpose bowl as described above
(fig. 5).
0 Place sieve insert of citrus press (fig.
13/a) on all-purpose bowl (mark
mark ) and turn cunter-clockwise to
the stop. The sieve insert can be heard to
engage (mark on mark
0 Insert press cone (fig. 13/b) in sieve
insert.
Operating citrus press
0 Start appliance: turn speed selector
(fig. 1/I) right to position 1.
The citrus press must only be operated
3
at the lowest speed.
0 Switch off appliance: turn speed selec-
tor left to the "0" position.
0 Remove press cone after use.
0 Turn sieve insert clockwise and remove.
0 Turn all-purpose bowl clockwise and
remove.
The appliance can be used for up to
1
10 minutes without stopping. It should
be allowed to cool each time following
prolonged, continuous operation (for
at least 20 minutes after using for
10 minutes without stopping).
on
).