AEG Electrolux FP 4200 Gebrauchsanweisung Seite 18

822_949_452 FP4200-4400_AEG.book Seite 15 Donnerstag, 12. Februar 2009 11:19 23
• Never leave the appliance unattended
when on and supervise particularly
carefully if young children are
around!
• Children should be supervised to
ensure that they do not play with the
appliance.
To be noted when using the food
processor
• Never put the appliance into use when
the hands are wet.
• No paints (lacquer, polyester, etc.) must
be stirred with the appliance – Explo-
sion danger!
• Switch the appliance off and withdraw
the mains plug each time before clean-
ing and maintenance.
• Never dip the motor casing (fig. 1/A) in
water or other liquids.
• The manufacturer accepts no liability
for possible damage caused by
improper or incorrect use.
• The tools must only be inserted or
removed from the appliance when it is
disconnected from the mains supply.
• Caution: The metal blade (fig. 1/Q) is
extremely sharp! Danger of injury!
The metal blade should only be held by
the handle and only stored with the
blade protector fitted! Caution when
rinsing!
• Caution: The cutting inserts (fig. 9)
are very sharp! Danger of injury! Keep
the inserts only in the accessories com-
partment provided (fig. 1/K). Caution
when rinsing!
• Caution: The blade unit of the mixer
(fig. 14/a) is very sharp. Danger of
injury! Care should be taken when dis-
assembling and assembling the mixer.
• Caution: Never reach with the fingers
in the filling inlet (fig. 1/F)! Danger
of injury!
• Caution: No hard objects (e.g. spoons)
must be placed in the mixer while run-
ning and do not reach into the mix
container with the hands. Danger of
injury!
• The cover should only be removed
when the tools are stationary.
• Do not hold long objects (blade,
wooden spoon, dough scraper or the
like) in the filling inlet. Danger of
injury! Work only with the stopper (fig.
1/E) to compress the cut food.
• Do not fill hot liquids (only cold or
warm) in the mix container or all-pur-
pose bowl.
• Always place the all-purpose bowl (fig.
1/G) on the motor casing before insert-
ing the spindle (fig. 1/H) and the tools.
• For normal work (stirring light doughs,
etc.) the appliance can be used for up
to 10 minutes without stopping. It
should be allowed to cool each time
following prolonged, continuous oper-
ation (for at least 20 minutes after
using for 10 minutes without stop-
ping). When processing very heavy
items, e.g. 1.5 kg dough, the appliance
should not be switched on for longer
than 1 minute without stopping.
• Always first remove the tools and spin-
dle before removing the contents of
the bowl.
• Do not exceed the maximum filling
volume.
• Only use the appliance under supervi-
sion. The mains plug should be with-
drawn even when leaving the room for
a short time.
• After finishing work switch off the
appliance and withdraw the mains plug.
General operating
instructions
Overload cut-out (FP4400)
The appliance is equipped with an
overload cut-out, which switches the
appliance off if it starts to overheat,
protecting the unit from damage.
When this happens, the overload cut-
out reset button (fig. 1/N) jumps out.
g
15