Maintenance; Securing The Device; Battery Replacement; Fuse Replacement - ZA-TEC ZA 1-3 Bedienungsanleitung

9.

Maintenance

Before opening the ZA-TEC ZA 1-3, make sure that the device

is free of voltage! Electrical danger!
Working on the opened ZA-TEC ZA 1-3 under voltage must be carried out by
skilled electricians with special precautions for the prevention of acci-
dents only!
Make sure that the ZA-TEC ZA 1-3 is free of voltage as described below before
opening the device:
- First, remove both safety measuring leads from the object to be measured.
- Then, remove both safety measuring leads from the ZA-TEC ZA 1-3.
- Switch the rotary switch  to position „OFF".

9.1 Securing the device

Under certain circumstances, safe operation of the ZA-TEC ZA 1-3 might no
longer be ensured, e.g. in case of:
- visible damages of the housing,
- incorrect measuring results,
- recognizable consequences of prolonged storage under inadmissible condi-
tions and
- recognizable consequences of extraordinary stress due to transport.
In such cases, immediately switch off the ZA-TEC ZA 1-3, disconnect it from the
measuring points and secure it against further use.
9.2 Cleaning
Clean the exterior of the device with a clean dry cloth (exception: special
cleaning wipers). Do not use any solvents and/or abrasives to clean the device.
Make sure that the battery compartment and the battery contacts are not con-
taminated by leaking battery electrolyte.
If there are electrolyte contamination or white deposits in the area of the battery
or the battery compartment, clean these areas as well by means of a dry cloth.

9.3 Battery replacement

Before opening the ZA-TEC ZA 1-3, make sure that the device

is free of voltage! Electrical danger!
The ZA-TEC ZA 1-3 is supplid by means of two integrated 1.5 V micro (AAA)
batteries.
Battery replacement (see figure 13) is required, if the battery symbol  appears
on the display .
Proceed as follows to replace the battery:
- Disconnect the safety measuring leads from the measuring circuit.
- Disconnect the safety measuring leads from the ZA-TEC ZA 1-3.
- Switch the rotary switch  to position „OFF".
- Put the ZA-TEC ZA 1-3 face down and unscrew the screw of the battery
compartment cover.
- Lift off the battery compartment cover from the bottom part of the battery
compartment.
- Remove the discharged batteries from the battery compartment.
- Insert the new batteries into the battery compartment observing correct po-
larity.
- Lock the battery compartment cover into place on the bottom part and
tighten the screw.
See figure 13:
Make your contribution for environmental protection! Do not
dispose of discharged batteries via the household waste.

Instead, return them to a collecting point for discharged bat-
teries or special waste. Please look for information in your
community's facilities.

9.4 Fuse replacement

Before opening the ZA-TEC ZA 1-3, make sure that the device

is free of voltage! Electrical danger!
The ZA-TEC ZA 1-3 is protected against overload by means of an integrated
fuse (G fusible insert) 10 A (see figure 14). Proceed as follows to replace the
fuse:
- Disconnect the safety measuring leads from the measuring circuit.
11/ 2016
Battery replacement
ZA-TEC ZA 1-3

19