Notices To The User; Repeater Operation - Kenwood NXR-5700E Anleitung

Firmware Copyrights
The title to and ownership of copyrights for firmware embedded in KENWOOD product memories are reserved for JVC KENWOOD
Corporation.
Information on Disposal of Old Electrical and Electronic Equipment and Batteries (applicable for countries that have
adopted separate waste collection systems)
Products and batteries with the symbol (crossed-out wheeled bin) cannot be disposed as household waste.
Old electrical and electronic equipment and batteries should be recycled at a facility capable of handling these items and
their waste byproducts.
Contact your local authority for details in locating a recycle facility nearest to you.
Proper recycling and waste disposal will help conserve resources whilst preventing detrimental effects on our health and
the environment.
• Do not expose the unit to rain or moisture; to prevent fire or electric shock.
• Do not open the unit under any circumstances; to avoid risk of electric shock.
• Do not expose the unit to long periods of direct sunlight, nor place it close to heating appliances.
• Do not place the unit in excessively dusty and/or humid areas, nor on unstable surfaces.
• Do not put the plastic bag used for packing of this equipment on the place which reaches a small child's hand. It will become a cause
of suffocation if it wears flatly.
• Always switch the repeater power off before installing optional accessories.
• If you detect an abnormal odor or smoke coming from the unit, disconnect the power from the unit immediately. Contact your
KENWOOD service center or dealer.
CAUTION
◆ This repeater is intended for use as a fixed base station with the antenna located outdoors on the rooftop or on an antenna tower.
◆ This repeater is designed for a 13.2 V DC power source. Never use a 24 V DC or higher source to power the repeater.
◆ Use only the supplied DC cord.
◆ Do not remove the ferrite core attached to the DC cord. Doing so may cause interference with radio communications.
◆ Do not put anything on top of the repeater. This will obstruct heat dissipation.
WARNING
Do not install the repeater in explosive atmospheres (inflammable gas, dust particles, metallic powders, grain powders, etc.).
When power is applied to the unit, the POWER indicator lights green. Turn the VOLUME control clockwise until a click
sounds, to unmute the audio. Rotate to adjust the audio. Turn the VOLUME control counterclockwise fully to mute the audio.
The BUSY indicator lights green while receiving a signal and the TX indicator lights red while transmitting.

NOTICES TO THE USER

PRECAUTIONS

REPEATER OPERATION

1 < REP_NOTICE_BASIC OP >