Installing The Stove; Stove Rotating; Minimum Distance From Combustible Or Load-Bearing Walls - Konigshutte Virgo Anleitung

Installing the stove

The floor on which the stove is installed must be even
and horizontal. The stove may only be installed on an
adequate load-bearing floor. The stove can be stood
on a metal floor sheet or glass sheet to protect the
flooring.
If the flooring or carpet is inflammable, a stable, heat
proof spark protection plate must be used. This must
extend 50 cm to the front and 30 cm to each side be-
yond the edge of the combustion chamber opening.
Under the stove no spark protection plate is required.

Stove rotating

The stove is delivered with the arrest engaged
(non-rotating). If the stove should rotate, the arrest on
the underside of the footrest must be unscrewed and
removed (see Fig.2).
Attention: Only with the top connection can the stove
be rotated via the footrest in 5 stages, 45°
to the left and the right.
Fig.1 Footrest
Fig.2 Arrest
12
Minimum distance
from combustible or load-bearing walls
There must be no objects made of combustible materi-
als within a distance of 100 cm of the stove's radiation
area, measured from the combustion chamber's in-
spection glass, nor may any be placed within this area
subsequently.
Depending on whether the stove is installed with the
arrest engaged (non-rotating) or rotating, different min-
imum wall distances that must be complied with apply,
based on the position of the combustion chamber door
to the set-up wall or side wall (see Fig. 3 to 6).
Stove with arrest engaged
The wall distances for non-rotating installation are pre-
sented below.
40 cm
Fig.3 Stove with arrest engaged,
installed straight in corner
25 cm
Fig.4 Stove with arrest engaged,
installed diagonally in corner
40 cm