Changing The Battery Of The Remote Control - EASYmaxx LPS-GD-05RG Gebrauchsanleitung

6. Connect the mains adapter to a properly installed plug socket.
7. Before you use the remote control for the fi rst time, pull the insulation strip out of the
battery compartment to activate the battery.
8. If the spotlight does not switch on automatically after you have connected it, point the
remote control at the front of the spotlight and press one of the
CAUTION: Laser Radiation! Do not look directly into the beam. Laser radiation
can result in blinding and permanent damage to the eyes.
The distance between the remote control and the spotlight should be no more
than 7 metres.
At low temperatures it can take a few minutes until the spotlight lights up fully.
9. By pressing the buttons on the remote control, the following functions can be called
up:
m
l
k
j
i
h
If the spotlight stops responding to the remote control, it is possible that the glass cover
may be dirty or the battery may be too weak and need to be replaced (see below).

Changing the Battery of the Remote Control

pull
press
13
5. Plug the cable connector into the socket on the mains
adapter that is also supplied. Screw the cap nut onto the
thread of the mains adapter.
a Increase / reduce brightness
b Flash
a
c AUTO (change colour)
b
d Timer buttons 3, 5, 8 (fi rst select function and then press
c
the timer button): daily lighting time in hours. Exam-
ple: With 3 the light switches off after 3 hours and then
d
switches back on after 21 hours.
Stop Switch off timer
e
e Flashing speed: + increase /
- reduce (laser)
f 3 - Switch between red, red / green, green (laser)
g 2 - Switch between red and green (laser)
f
h 1 - Light up constantly (laser)
g
i Laser colour select (green, red / green, red)
j Switch laser on / off
k Speed: + increase / - reduce (light)
l Light colour select
m Switch light on / off
1. The battery compartment is located on the narrow side of
the remote control. Pull it out as shown.
2. Take the used battery out and insert a 3 V battery of the
CR2025 type. The positive pole must be facing upwards.
3. Push the battery compartment back into the remote con-
trol to the limit stop.
EN
buttons (On / Off).