Operation; Control Panel; Switching Off; Temperature Regulation - Küppersbusch ITE1260-2 Benutzerinformation

OPERATION

Control panel

Power indicator light
1
Temperature regulator
2
FastFreeze light
3
Switching on
Connect the appliance to the main power
supply.
1. Turn the Temperature regulator
clockwise to a medium setting.
The power indicator light will light up and a
sound will signal for 2 seconds.
If the temperature inside the
appliance is too high, the Alarm
light will blink and the sound
signal alarm will turn on.
2. Push the FastFreeze switch and the
sound signal alarm will get off.
3. Push the FastFreeze switch once again
and the FastFreeze light will light up.
The appliance will start to operate.

Switching off

Turn the Temperature regulator to the "O"
position and a sound is on only for 2
seconds .
The power indicator light will switch off.

Temperature regulation

The temperature is regulated automatically.
1 2 3 4 5
FastFreeze switch and alarm reset
4
switch
Alarm light
5
A medium setting is generally
the most suitable.
However, the exact setting
should be chosen keeping in
mind that the temperature inside
the appliance depends on:
• room temperature,
• how often the door is
opened,
• the quantity of food stored,
• the location of the appliance.
1. Turn the Temperature regulator toward
lower settings to obtain the minimum
coldness.
2. Turn the Temperature regulator toward
higher settings to obtain the maximum
coldness.
CAUTION! If the ambient
temperature is high or the
appliance is fully loaded, and the
appliance is set to the lowest
temperatures, it may run
continuously causing frost to
form on the rear wall. In this
case the dial must be set to a
higher temperature to allow
automatic defrosting and
therefore reduced energy
consumption.
5