Parts Description; Mounting The Unit; Operation And Maintenance - TriStar KA-5283 Bedienungsanleitung

Instruction manual

PARTS DeSCRIPTION

1. Heater
2. Switch cord
3. Plastic collar
4. Base

OPeRATION AND MAINTeNANCe

• Remove all packaging of the device.
• Check if the voltage of the appliance corresponds to the main voltage
of your home. Rated voltage : AC220-240V 50Hz
4

MOUNTING THe UNIT

1
• Place the base (No. 4) on a flat surface and unscrew the three screws.
2
• Place the rod with the ring at the bottom of the foot in the hole, so the
three screw holes of the rod with the ring are exactly above the three
holes of the foot. Tighten it with three screws.
3
• Remove the cable guidance clip and slide the plastic cover over the connec-
tion of the foot and the rod. Then install the cable guidance clip again.
• Place the other two rods together and tighten the screw which is
already attached in the rod. Make sure that the rod with the plastic
collar is mounted at the top.
• Mount the heater (No. 1) on the thin rod and tighten the screw.
• Turn the plastic collar (No. 3) of the rod and slide this over the thin rod,
place the heater in the holder and set the desired height of the heater.
Turn the plastic collar securely.
• Guide the cable along the rod through the 2 cable guidance clips
downwards.The device is ready for use.
Mounting the unit to a wall
4
• If the heater is placed on a wall, the
rods and the foot are not necessary.
• Mount the supplied bracket to a solid
straight wall.
• Attach the heater to the holder.
• Keep on top and sides at least 50 cm.
free space.
• Place the heater at least 180 cm. above
the ground.