Preparation Before Use; Connecting The Ac Adapter - JVC GV-LS2WE Benutzerhandbuch

Preparation before Use

Connecting the Camera to
Your Computer
To set up the camera, fi rst connect it to
your computer.
Required operating environment
Browser: Internet Explorer 9 or later
1 Attach the LAN cable to the camera.
RESET
DIRECT WLAN
ETHERNET
2 Connect the camera to your
computer via the supplied LAN
cable.
3 Set the network mode switch to
[LAN (OFF)].
DIRECT WLAN LAN(OFF)
• If the network mode switch is set to
[DIRECT] or [WLAN], the LAN terminal
cannot be used.
• While the power is on, switching the
network mode switch does not change
the setting.
• Do not use cables (AV cable,
microphone, etc.) with L-shaped
connecters.
For more details, refer to the Detailed User Guide at http://manual3.jvckenwood.com/
MIC
DC
LAN(OFF)
AV
MIC
RESET
DC
DIRECT WLAN LAN(OFF)
AV
ETHERNET

Connecting the AC Adapter

Connect the supplied AC adapter to the
DC connector of the camera.
AC adapter
Configuring the Camera Settings
Appropriate for Your Needs
Specify the video format, zoom, etc.
appropriate for your needs. Confi gure the
settings on a browser.
Logging in as an administrator
1 If the power is not turned on, press
and hold the [POWER] button to
power on.
The record button starts blinking. Wait
until it stops blinking and goes off.
2 Set the Network Setting of the
computer as follows.
IP Address: 192.168.1.2 to
192.168.1.254 (except 192.168.1.100)
(example) 192.168.1.23
Subnet mask: 255.255.255.0
Make a note of the current network
settings before operation for resetting
the network setting.
3 Start Internet Explorer, and enter
"http://192.168.1.100:8000" in the
address bar.
MIC
RESET
DC
DIRECT WLAN LAN(OFF)
AV
ETHERNET
Conversion cable
9